MAX WATER PRODUCT FEATURES:
- 1st Stage - 1 Micron Polypropylene Sediment Filter
To remove larger & small particles & suspended matter such as dirt, silt, rust, sand, algae, sediment, scale particles, dirt and cloudiness from water.
Replace every 6~12 months
- 2nd Stage -T33 GAC Coconut Shell Granular Activated Carbon Filter + PP Filter Cartridge.
To remove chlorine, pesticides, herbicides, bad taste & odours. and carbon fines may pass from first or second stage "same stage"
Operating Temp.: 4.4℃-52℃
Filtration Life: 3-6 months or 2500gallons (Depending on water quality and level of contaminants)
Max. Operating Pressure: 80psi
Max. Flow rate: 2.5GPM
Replace every 6~12 months or lasts 2,500 gallons
- 3rd Stage – Carbon Block Filter
It Takes 99% of the chlorine & organic chemicals also removes herbicides, pesticides, chlorine bi-products to protect membrane
Replacement each 6 months or lasts 3,000 gallons.
- 4th Stage - Fillit TFC Membrane 100 Gallons per day Model # TW-2012-100GPD
(FILMTEC MEMBRANE MATERIAL)
To remove particles down to 1/10,000 of a micron (which is 98% of impurities
Including Organic and inorganic, chemicals).
Replace every 2 years.
- 5th Stage – DI filter ( Mix Bed Resin ) named as de-ionization stage
Demineralization Resin used to produce 99.99% pure water by simply attaching this convenient deionization filter with RO unit. Convenient post RO filtration DI unit (RO/DI unit) provides crucial supplemental filtration to remove most impurities for pure polished product water. Excellent in areas with hard water. Produce 99.99% pure water. It will give you 0 ppm TDS, Conductivity attainable less than 0.1uS/cm or resistivity of close to 18 meg.ohm. Simply DI filter removes remaining of dissolved solids after RO system
Replace every 6 months or lasts 1,500 gallons