9 Stage RO System replacement Filter Set 3 in 1 Alkaline DI (w/o Membrane)

9 Stage RO System replacement Filter Set 3 in 1 Alkaline DI (w/o Membrane)

1 Set of Replacement Filters
// contains the following

1x Sediment Filter 5 micron Dirt/Rust remover

• Size 2.5" x 9 7/8" Fits most standard 10" size housings and most reverse osmosis systems.
• Used to remove larger particles & suspended matter such as dirt, silt, rust, sand, algae, sediment, scale particles, and cloudiness from water.
• Meets FDA requirements for food and beverage contact
• No leach able or extractable to contaminate
• Long life and increased dirt holding capacity
• No surface binders to reduce flow and increase change-out frequency

1x GAC UDF 10” Coconut Shell Carbon Filter

• Size 2.5" x 9 7/8" Fits most standard 10" size housings and most reverse osmosis systems.
• Remove Chlorine, Turbidity, Bad Taste & Odor, Sediment, Dirt, and THMS from water.
• Thick Wall Coconut Base Carbon Filter Media // 100% coconut shell carbon Designed For maximum contact between the water and carbon
• 05 Micron Nominal filter membrane included to prevent carbon fines to pass from the filter to your drinking water.
• Operation Temperature: 40°F to 125°F
• Lower pressure drop

1x CTO Carbon Block Filter

• Size 9 7/8 inch x 2.5 inch Fits most standard 10 inch size housings and most reverse osmosis systems.
• Remove small particles and carbon fines may pass from second stage & to ensure 100% of chlorine removal from water.

1x Standard Inline Carbon Cartridges

• Dimensions: 2 inch x 10 inch - Fits all Reverse Osmosis Systems.
• Filter Service Life 1500 Gallons (5676 Liter)
• Max Flow: 0.75 GPM
• Max Pressure: 125 PSI (8.6 Bar)
• Max Temperature: 100°F
• Inlet/Outlet: 1/4 inch NPT

1 x 3-in-1 pH+ Alkaline/Far Infrared/Remineralization Filter

• Filter Service Life: 6 to 18 months maximum, Filter life varies and will be determine based on of the feed water quality and amount water the machine produce.
• Filter in out port size: 1/4" NPTF. Filter Size: 2"W x 10"L
• Required Hardware:Two 1/4" FTP Fittings ( 1/4" tube connecters ) are required to connect this filter to your RO unit. part number: 105407,
• Two 2"x2.5" double clamp are required to mount the filter to your RO system. part number: 105104

1x Refillable Inline Mixed Bed Deionization Filter (Double Ended)

• Clear Housing, Refillable Cartridge (Double Ended)
• Filter Media: Mixed Bed ion exchange resin
• Max Flow: 0.5 GPM
• Max Pressure: 125 PSI
• Max Temperature: 100°F
• Dimensions: 11 inch x 2 inch
• Inlet/Outlet: 1/4 inch FPT
• Weight: 13 oz

Total 6 filters, each individually wrapped