Quartz for UV Part # 105083 and # 105086
Replacement Quartz Sleeve for UV Systems 105083 and 105086
This replacement quartz sleeve is designed for compatible Max Water ultraviolet water sterilizers, including UV system Part Nos. 105083 and 105086.
The quartz sleeve creates a watertight barrier between the UV lamp and the water flowing through the stainless-steel reactor chamber. Its transparent surface allows ultraviolet light to pass through while protecting the lamp from direct contact with water.
Compatibility: Designed for compatible Max Water UV systems 105083 and 105086. Always confirm the sleeve length, outside diameter, inside diameter, and system model before ordering.
Key Features
- Replacement quartz sleeve for compatible UV water sterilizers
- Compatible with Max Water systems 105083 and 105086
- Protects the UV lamp from direct water contact
- Allows UV light to pass into the treatment chamber
- Smooth surface for easier inspection and cleaning
- Suitable for residential and commercial UV systems
Technical Specifications
| Specification | Details |
|---|---|
| Compatible UV Systems | Part Nos. 105083 and 105086 |
| Outside Diameter | Approximately 0.90 inch |
| Inside Diameter | Approximately 0.77 inch |
| Overall Length | Approximately 37 inches |
| Material | UV-transmitting quartz glass |
| Quantity Included | One replacement quartz sleeve |
When Should the Quartz Sleeve Be Replaced?
- The sleeve is cracked, chipped, or broken
- The surface remains cloudy after cleaning
- Mineral scale or staining cannot be removed
- The sleeve no longer seals correctly inside the UV chamber
- The UV lamp has been damaged by water entering the sleeve area
Important: A dirty or cloudy quartz sleeve can reduce the amount of UV light reaching the water and lower the sterilizer's treatment performance. Inspect and clean the sleeve regularly.
Installation Guidelines
- Disconnect electrical power before servicing the UV system
- Shut off the water supply and relieve system pressure
- Allow the UV lamp and chamber to cool before disassembly
- Remove the UV lamp carefully before removing the quartz sleeve
- Handle the quartz sleeve gently to avoid cracking or chipping
- Inspect the O-rings and seals before reassembly
- Replace worn, damaged, or flattened O-rings when necessary
- Check for leaks before reconnecting electrical power
Handling Warning: Quartz glass is fragile. Do not force the sleeve into the chamber, overtighten the retaining nut, or allow the sleeve to strike hard surfaces.
Product Notice: Measurements are approximate. Confirm compatibility with your existing UV system before ordering, especially if your unit has been modified or uses a different production-batch configuration.
(14)
(1)
(3)
(5)
(1)
