Blog -- Disable

Blog

What is Reverse Osmosis and what types of contaminants does the Reverse Osmosis system remove?
Reverse Osmosis (RO) water purification systems can reduce and eliminate TDS‡ like salts and minerals from your drinking water.
By Max Water May 19, 2023
Read More
How can I connect and/or disconnect the tube from a quick type fitting?
Please make sure you follow these instructions in full detail to avoid any leaking problems. Prepare the connection: Cut the tube square ensuring...
By Max Water May 10, 2023
Read More
Why Does the Water From My Reverse Osmosis System Seem Cloudy or Milky?
This is generally caused by trapped air within the RO system. However, it will not affect the quality of your water. The cloudiness should disappear...
By Max Water Apr 25, 2023
Read More
How do I convert my aquarium system into a drinking system?
To convert an aquarium into a drinking water system, follow these steps for safety and suitability.
By Max Water Apr 15, 2023
Read More
How to Replace the O-Rings in a Quick Connect Fitting?
These instructions for repai—ring quick connect fitting such for John Guest fitting. Turn off the incoming feedwater inlet line and open a...
By Max Water Mar 20, 2023
Read More
Where should I go to test my water sample?
Please click on this link to show you all Ontario-licensed laboratories
By Max Water Mar 12, 2023
Read More
I am getting weird sounds from my RO system?
Usually, the sound presents for many reasons. High pressure, low pressure, and auto shut failer after 5 years. * Hi, pressure more than 75...
By Max Water Feb 28, 2023
Read More
Adding Air to the Reverse Osmosis Storage tank?
When water stops running out from the faucet; check the tank weight, if it's more than 10 Lbs, that means that the tank air pressure is down.
By Max Water Feb 18, 2023
Read More
Why did my filter housing(s) crack?
There are many reasons that caused the filter housings to be cracked: the most common reasons are freezing or hitting the housing on the floor...
By Max Water Jan 21, 2023
Read More
Why is my membrane fouling or clogged too fast?
Membrane fouling can significantly impair the effectiveness of filtration processes by causing particle build-up in the membrane's pores...
By Max Water Jan 10, 2023
Read More
Maple Syrup to Sap steps guides
As a maple syrup producer, you can improve the efficiency and quality of your production process by using a 4040 commercial reverse osmosis...
By Max Water Dec 23, 2022
Read More
What Causes filter house Plastic Shrinkage / Cracking?
Plastic shrinkage cracking almost always occurs because the surface dries too quickly before it has time to strengthen. Rapid evaporation...
By Max Water Dec 16, 2022
Read More
Why my RO PPM is high?
For a newly installed system, you have to check the following, make sure that you insert/load the membrane inside the membrane...
By Max Water Nov 14, 2022
Read More
How do you change your whole house's pressure gauges?
If you would like to install or exchange the old gauges with new pressure gauges, please remove all the old Teflon tape from the pressure gauges...
By Max Water Nov 05, 2022
Read More
I purchased a whole house filter set and installed it, but then my flow rate dropped.
First, make sure that you install the filters in the correct flow direction (ie. if your system flow is Right to Left, make sure to install the Sediment filter...
By Max Water Oct 11, 2022
Read More
What’s the Difference Between POU and POE Water Filtration Systems?
POU (Point-of-Use) and POE (Point-of-Entry) water filtration systems are two different types of water treatment systems that serve distinct...
By Max Water Oct 04, 2022
Read More
How do I correctly apply Teflon Tape to threading?
For a newly installed system, you have to check the following Make sure that you insert/load the membrane inside the membrane...
By Max Water Sep 13, 2022
Read More
Why Sediment filter required before Iron Manganese filter.
In most cases with Iron Content in the water, the water itself will usually contain different types of contaminants/sediments/dirt, etc. When your...
By Max Water Sep 02, 2022
Read More
My RO system is not producing enough water or the tank is not filling.
It could be any of the following: Check your tank pressure Check your pre-filters quality, if the sediment filter is clogged with dirt...
By Max Water Aug 27, 2022
Read More

Blog -- Disable

What is Reverse Osmosis and what types of contaminants does the Reverse Osmosis system remove?

By Max Water May 19, 2023

How can I connect and/or disconnect the tube from a quick type fitting?

By Max Water May 10, 2023

Why Does the Water From My Reverse Osmosis System Seem Cloudy or Milky?

By Max Water Apr 25, 2023

How do I convert my aquarium system into a drinking system?

By Max Water Apr 15, 2023

How to Replace the O-Rings in a Quick Connect Fitting?

By Max Water Mar 20, 2023

Where should I go to test my water sample?

By Max Water Mar 12, 2023

I am getting weird sounds from my RO system?

By Max Water Feb 28, 2023

Adding Air to the Reverse Osmosis Storage tank?

By Max Water Feb 18, 2023

Why did my filter housing(s) crack?

By Max Water Jan 21, 2023

Why is my membrane fouling or clogged too fast?

By Max Water Jan 10, 2023

Maple Syrup to Sap steps guides

By Max Water Dec 23, 2022

What Causes filter house Plastic Shrinkage / Cracking?

By Max Water Dec 16, 2022

Why my RO PPM is high?

By Max Water Nov 14, 2022

How do you change your whole house's pressure gauges?

By Max Water Nov 05, 2022

I purchased a whole house filter set and installed it, but then my flow rate dropped.

By Max Water Oct 11, 2022

What’s the Difference Between POU and POE Water Filtration Systems?

By Max Water Oct 04, 2022

How do I correctly apply Teflon Tape to threading?

By Max Water Sep 13, 2022

Why Sediment filter required before Iron Manganese filter.

By Max Water Sep 02, 2022

My RO system is not producing enough water or the tank is not filling.

By Max Water Aug 27, 2022